MIRCERA pre-filled syringe Instructions For Use
The following instructions explain how to use the MIRCERA pre-filled syringe to give yourself an injection.
It is important to read and follow these instructions carefully so that you are able to use the pre-filled syringe correctly and safely.
Do not attempt to administer an injection until you are sure that you understand how to use the pre-filled syringe.
IMPORTANT INFORMATION
• Only use MIRCERA pre-filled syringeif you have been prescribed with this medication.
• Read the packaging and ensure you have the dose prescribed by your healthcare professional.
• Do not use the pre-filled syringe if syringe, or the plastic tray containing the syringe appears to be damaged.
• Do not use the syringe if the contents are cloudy, hazy or contain particles.
• Never attempt to take the syringe apart.
• Never pull on or handle the syringe by its plunger.
• Do not remove the needle shield until you are ready to perform an injection.
• Do not swallow the medicine in the syringe.
• Do not inject through clothing.
• Never re-use a syringe.
• Do not touch the release clips (see diagram below) as this may damage the syringe and make it unusable.
STORAGE
Keep the syringe and the puncture-resistant/ sharps container out of the reach of children.
Store the syringe in its original box until ready to use.
Always store the syringe in a refrigerator at a temperature of 2 - 8°C (35.6 - 46.4°F).
Do not allow the medicine to freeze, and protect the medicine from light. Keep the syringe dry.
MATERIALS Included in the pack:
A pre-filled syringe of MIRCERA and a separate injection needle
Not included in the pack:
HOW TO GIVE THE INJECTION
Step 1: Allow the syringe to adjust to room temperature
Step 2: Clean your hands
Step 3: Unpack and visually inspect the pre-filled syringe
Step 4: Attach the needle to the syringe
Step5: Remove the needle shield and prepare for injection
Step 6: Perform the injection
There are two different ways (routes) to inject MIRCERA into your body.
Follow the recommendations of your healthcare professional about how you should inject MIRCERA.
Subcutaneous route: If you are advised to inject MIRCERA under your skin, please administer your dose as described below.
Choose one of the recommended injection sites as shown. You may inject MIRCERA into the upper arm, thigh or abdomen, except around the navel (belly button).
Place a sterile cotton ball or gauze over the injection site and press for several seconds.
• Do not rub the injection site with dirty hand or cloth.
• If needed, you may cover the injection site with a small bandage.
Dispose of the syringe:
• Throw away used syringes in a sharps/ puncture-resistant container.
• Do not try to replace the needle shield on the needle.
• Do not throw away used syringes or the sharps/ puncture-resistant container in household trash and do not recycle them.
• Dispose of the full container as instructed by your healthcare provider or pharmacist.
Intravenous route:
If your healthcare professional has recommended injection of MIRCERA into a vein, you should follow the procedure described below. After preparation of the syringe as described in steps 1 to 5:
Push the plunger with the thumb while holding the syringe with the forefinger and the middle finger against the finger grips until all the medicine is injected.
Remove the pre-filled syringe from the venous port WITHOUT releasing the plunger. Release the plunger, allowing the needle guard to protect the needle.
Now, the tear-off label can be removed, if necessary.
Dispose of the syringe:
Throw away used syringes in a puncture-resistant container.
• Do not try to replace the shield on the needle.
• Do not throw away used syringes or the puncture-resistant container in household trash and do not recycle them.
• Dispose of the full container as instructed by your healthcare provider or pharmacist.
Comments